|
Post by w3365203 on Jun 18, 2022 4:34:55 GMT
Hi there,
There is Fan SpeedRPM under SpeedPercent under Fan Schema.
SpeedPercent { DataSourceUri Reading, SpeedRPM (v1.2+) }
My question is, where should i put the data source for speedRPM? There should be two data sources, one for speed percent and the other for Speed RPM.
Thanks
|
|
|
Post by mraineri on Jun 20, 2022 14:59:15 GMT
Both are expected to come from the same URI. A Sensor resource that conveys the fan speed percent can also have a "SpeedRPM" property. For example:
{ "@odata.type": "#Sensor.v1_5_0.Sensor", "Id": "PS1Fan", "Name": "Power Supply #1 Fan", "Oem": {}, "PhysicalContext": "PowerSupply", "Reading": 68, <--- This reflects the fan speed percent "SpeedRPM": 3290, <--- This is the speed as an RPM "ReadingRangeMax": 100, "ReadingRangeMin": 0, "ReadingType": "Percent", "ReadingUnits": "%", "Status": { "Health": "OK", "State": "Enabled" }, "Thresholds": { "LowerCaution": { "Reading": 5 }, "LowerCritical": { "Reading": 0 } }, "@odata.id": "/redfish/v1/PowerEquipment/PowerShelves/1/Sensors/PS1Fan", "@Redfish.Copyright": "Copyright 2014-2021 DMTF. For the full DMTF copyright policy, see http://www.dmtf.org/about/policies/copyright." }
|
|