Post by saravanans on Nov 27, 2023 14:13:35 GMT
Hello all,
I have successfully configured IPv6 (DHCPv6) between two laptops. Now, I am attempting to connect an EVB-AST2600 board to my laptop using an Ethernet cable. I have enabled dhcpcd in the configuration file and need to set up IPv6 for communication between the EVB-AST2600 board and my laptop.
The server configuration is working correctly, but I am unsure about the exact client configuration.
Here is my dhcpcd.conf file.
ipv6
interface eth1
ipv6 enable
ipv6 address auto global default
dhcpv6 client information-request
interface GigabitEthernet0/0/1
port link-type access
port default eth1
Kindly help me to rectify this issue
I have successfully configured IPv6 (DHCPv6) between two laptops. Now, I am attempting to connect an EVB-AST2600 board to my laptop using an Ethernet cable. I have enabled dhcpcd in the configuration file and need to set up IPv6 for communication between the EVB-AST2600 board and my laptop.
The server configuration is working correctly, but I am unsure about the exact client configuration.
Here is my dhcpcd.conf file.
ipv6
interface eth1
ipv6 enable
ipv6 address auto global default
dhcpv6 client information-request
interface GigabitEthernet0/0/1
port link-type access
port default eth1
Kindly help me to rectify this issue
